Filter
Top Products
What’s New at Revision 8.2.0? 15
2 Enter the number(s) of the slot(s) that contain ports you want to set to
IFM mode:
10-12
For each slot you entered, the system prompts you for specific port
numbers:
Select Ethernet port(s) (1-8,all):
3 Enter the number(s) of the port(s) that you want to configure:
1,2,5-7
You receive the prompt to enable or disable IFM mode for each
selected port:
Enter new value (disabled, enabled) [disabled]:
4 Enter enabled to set the port to IFM mode or disabled to deactivate
IFM for the port.
Default The port’s current setting is indicated within square brackets. To select
this default, press [Return]. This action leaves the port unchanged.
5 Repeat step 4 to configure all the selected ports in all the selected
slots.
Bridge MIB Support for the FESM
FESM support has been added to the Bridge MIB.
Filter MIB Support
Support for the Filter MIB (address group, port group, and bridge packet filter
program) has been added.
FTP Packet Filter Program Transfers via SNMP
You can now use File Transfer Protocol (FTP) to transfer a user-defined
packet filter program from a remote server to a CoreBuilder 6000 switching
module through the SNMP lpsFtTable MIB.