Filter
Top Products
C
ORE
B
UILDER
6000
I
NTELLIGENT
S
WITCHING
S
OFTWARE
R
EVISION
8.2.0
Overview
These installation instructions and release notes describe revision 8.2.0 of
the CoreBuilder
™
6000 Intelligent Switching software from 3Com
Corporation, dated May 8, 1997. This revision supersedes revision 8.0.2,
dated December 2, 1996.
Extended Switching Software is also available. It supports IP, IPX, and
AppleTalk routing, VLANs, and RMON. To purchase Extended Switching
software, contact your sales representative.
Hardware
Dependencies
CoreBuilder Intelligent Switching software revision 8.0.0 or greater requires
that one of the following LANswitching Management Module Plus (LMM+)
versions be installed in system slot 1:
■
Revision 1.21 or greater of the revision 1 LMM+
■
Revision 2.12 or greater of the revision 2 LMM+
If you attempt to run CoreBuilder system software 8.0.0 or greater on an
earlier revision of the LMM+, the system fails to reboot automatically
when you turn it on.
To reboot a system that has failed to reboot automatically, connect a
terminal to the serial port on the LMM+ installed in the system. When
asked if you want to “ignore the checksum error,” enter
y
(
yes
). The system
reboots.