Filter
Top Products
6
C
ORE
B
UILDER
6000 I
NTELLIGENT
S
WITCHING
S
OFTWARE
R
EVISION
8.2.0
To copy the software to a UNIX hard disk, follow these instructions.
If the directory “/usr/lp6000” does not exist on your computer, create the
directory before proceeding. If your “/usr” directory is full, you can use a
different directory. If you use a different directory, substitute the actual
directory you use for “/usr” in this and subsequent procedures.
1
Insert diskette #1 into the disk drive. These instructions assume drive rfd0.
2
Extract the first part of the CoreBuilder software file using the following
commands:
# tar xvf /dev/rfd0
3
Remove diskette #1 using the following command:
# eject
4
Insert diskette #2 into the disk drive and extract the second part of the file
using the following command:
# tar xvf /dev/rfd0
5
Remove diskette #2 using the following command:
# eject
6
Insert diskette #3 into the disk drive and extract the third part of the file
using the following command:
# tar xvf /dev/rfd0
7
Remove diskette #3 using the following command:
# eject
8
Insert diskette #4 into the disk drive and extract the fourth part of the file
using the following command:
# tar xvf /dev/rfd0
9
Remove diskette #4 using the following command:
# eject
10
Insert diskette #5 into the disk drive and extract the fifth part of the file
using the following command: