Filter
Top Products
20 COREBUILDER 6000 INTELLIGENT SWITCHING SOFTWARE REVISION 8.2.0
Power Supply Warning Messages. This release of system software now
displays these power supply warning messages when appropriate:
■ +5V Failure
The power supply +5-volt input has failed.
■ +12V Failure
The power supply +12-volt input has failed.
■ +12V Restored
The power supply +12-volt input is restored.
■ +5V Restored
The power supply +5-volt input is restored.
■ Power Supply Over Temp
One of the power supplies has exceeded the allowable temperature of
90 degrees C.
SNMP Traps. When you insert and extract either of the power supplies,
the system generates SNMP traps.
Hot-swappable Fans. You can remove and replace either of the two fans
at the back of the chassis. When you remove a fan tray, the system
generates a sound and the control panel displays the following message:
Fan Failure
Insert the new fan following the instructions and safety messages in the
Installation Guide that comes with the new fan. The fan begins to function
immediately after you install it. The system control panel displays this
message:
Fan Restored