Blodgett 1060 Series Oven User Manual


 
Installation
5
Oven Assembly
PACKAGING
Before beginning assembly and installation of the
oven, check that all necessary components have
been received. In addition to the oven itself, legs,
the proper vent, and/or other a ccessories may be
required.
Single Sections
1060 with Steel Deck
D Legs, regulator, set of flue plates, draft diverter
and steel deck are shipped in the oven.
D Drafthood (when supplied) is packed separately.
1060 with Ultra Rokite Decks
D Legs, regulator, s et of flue plates and draft di-
verter are shipped in oven.
D UltraRokitedecksarepackedinaseparatecar-
ton.
D Drafthood (when supplied) is packed separately.
Double Sections
1060 with Steel Deck
D Legs and bolts, regulator, set of flue plates and
steel deck are pack ed in the lower section.
D Regulator, set of flue plates, draft diverter and
steel deck are pack ed in the upper section.
D Crown angle leg frame is packed in a separate
carton.
D Drafthood (when supplied) is packed in a sepa-
rate carton.
1060 with Ultra Rokite Decks
D Legs and bolts, regulator, set of flue plates are
packed in the lower section.
D Regulator, draft diverter and a set of flue plates
are packed in the upper section.
D UltraRokitedecksarepackedintwoseparate
cartons.
D Crown angle leg frame is packed in a separate
carton.
D Drafthood (when supplied) is packed in a sepa-
rate carton.
LEG ATTACHMENT
1. Put the oven onto a genie lift with the bottom
of the oven down. Be careful not to damage
the louvered panel under the oven.
2. Each leg is attached by three bolts to the un -
derside of the oven base frame.
CASTER ATTACHMENT
1. Boltsupportstoovenwith1/2-13hexhead
bolts(casterswithbrakesshouldbefacing
front of oven.)
2. Carefully place oven onto the casters. (It will
be necessary to have several persons lift oven
off the pallet and set it onto t he casters). En-
gage brakes on front casters.
NOTE: A fixed restraint must be provided if cast-
ers are used in conjunction with a flexible
connector for movable appliances. This
restraint must secure the oven to a non-
movable surface to eliminate stress on the
connector. If the oven is moved, the re-
straint must be reconnected after the oven
is returned to it’s normal position.