Filter
Top Products
Maintenance
17
Troubleshooting Guide
POSSIBLE CAUSE(S) SUGGESTED REMEDY
SYMPTOM: Oven will not fire.
S Gas turned off.
S Oven not plugged in.
S Power switch on the control panel is off.
S Control set below ambient temperature.
S Doors are open.
S No draft on the burner.
S TurnthegasvalvetoON.
S Plug in electrical supply cord.
S Set the control panel to ON.
S Set to desired cook temperature.
S Close doors.
S Check draft inducer opening.
SYMPTOM: Oven does not come to ready.
S The oven has not reached preheat temperature.
S Gas valve not t urned on completely.
S The quick disconnect is not connected.
S Gas pressure to oven is too low.
S Internal problem with main temperature control.
S Wait for oven to reach preheat temperature.
S Check the gas valve, turn on fully if necessary.
S Reconnect the quick connect. Check all gas
connections.
S Call your local gas representative.
S *
SYMPTOM: Convection fan does not run.
S Oven is not plugged in.
S Circuit breaker tripped.
S Doors are open
S Blower delay was set.
S Plug in electrical supply cord.
S Reset the breaker.
S Close doors.
S Reset blower delay time.
SYMPTOM: General baking problems.
S Thermostat out of calibration.
S Improper oven venting.
S *
S *
SYMPTOM: Rack does not stop rotating after doors are opened or rack stops in wrong position.
S Rack rotator sw itch out of position S Reposition rack rotator sw itch
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that
All repairs a nd/or adjustments be done by your local Blodgett service agency a nd not by the owner/operator. Blodgett cannot as-
sume responsibility for damage as a result of servicing done by unqualified personnel.
WARNING!!
Always disconnect the power supply before cleaning or servicing the oven.