Filter
Top Products
8
TROUBLESHOOTING
A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems
encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic
Technical Service Department.
• Inspection, testing, and repair of electrical equipment should be performed only by qualified service personnel.
• All electronic components have 120 volt ac and low voltage dc potential on their terminals. Shorting of
terminals or the application of external voltages may result in board failure.
• Intermittent operation of electronic circuit boards is unlikely. Board failure will normally be permanent. If an
intermittent condition is encountered, the cause will likely be a switch contact or a loose connection at a
terminal or crimp.
• Solenoid removal requires interrupting the water supply to the valve. Damage may result if solenoids are
energized for more than ten minutes without a supply of water.
• The use of two wrenches is recommended whenever plumbing fittings are tightened or loosened. This will help
to avoid twists and kinks in the tubing.
• Make certain that all plumbing connections are sealed and electrical connections tight and isolated.
• Keep away from combustibles.
WARNING – • Exercise extreme caution when servicing electrical equipment.
• Unplug the dispenser when servicing, except when electrical tests are specified.
• Follow recommended service procedures
• Replace all protective shields or safety notices
PROBLEM
PROBABLE CAUSE
REMEDY
CDS and Powder Auto-Fill do not
run - Main power indicator on CDS
drawer front OFF
Product level in CDS is lower than
level Probe - CDS running; Powder
Auto-Fill door lamp is OFF
Product level in CDS is lower than
level Probe - CDS running; Powder
Auto-Fill door lamp flashes ON and
OFF
1. CDS power cord disconnected or
main power switch in 0 position.
1. The CDS DAY/NIGHT switch in the
NIGHT position.
2. The CDS DAY/NIGHT timer in the
NIGHT position.
3. Powder Auto-Fill power cord dis-
connected.
4. Powder Auto-Fill main power
switch in OFF position.
5. Powder Auto-Fill door is open.
1. Low product in Powder Auto-Fill.
Check that the power cord is con-
nected to proper electrical source
and that the CDS main power switch
is in the 1 position.
1. The CDS DAY/NIGHT switch
should be in the DAY position.
2. Reprogram the CDS DAY/NIGHT
timer.
3. Check that the Powder Auto-Fill is
plugged into the back of the CDS
auger motor cover.
4. Select the ON position of the main
power switch.
5. The Powder Auto-Fill door should
be closed securely.
Remove hopper and fill with pow-
dered mix.
29793 061599