Filter
Top Products
9
TROUBLESHOOTING (cont.)
PROBABLE CAUSE REMEDYPROBLEM
Product level in CDS is lower than
level Probe - CDS running; Powder
Auto-Fill door lamp flashes two times
Product level in CDS is lower than
level Probe - CDS running; Powder
Auto-Fill door lamp flashes three
times
Product level in CDS is lower than
level Probe - CDS running; Powder
Auto-Fill door lamp flashes four times
The CDS product tastes "watery" or
"sugary"
Powder Auto-Fill dispenses dry prod-
uct only - dry powder build-up in
mixing and whipper chambers
1. Powder Auto-Fill not pulled com-
pletely forward.
2. CDS level probe misaligned.
1. Powder Auto-Fill hopper not in-
stalled.
2. Powder Auto-Fill hopper not in-
stalled properly.
1. Refill time exceeded five minutes.
1. Improper adjustment of product
mix ratio.
1. Powder Auto-Fill not connected to
water source.
2. Water source turned off.
3. Water line obstructed.
1. Check that the Powder Auto-Fill is
pulled completely forward until the
guide rails roll into the indented po-
sition.
2. Position the CDS level probe so
that it is located in the notch of the
CDS hopper and touching the con-
tact protruding from the front of the
CDS cooling drum mount.
1. Install the Powder Auto-Fill hop-
per.
2. Reposition the Powder Auto-Fill
hopper.
Check that the SERVICE switch is
released or reset by opening and
closing the Powder Auto-Fill door.
Adjust the product mix ratio per in-
structions in Powder Auto-Fill Ad-
justment. See page 5.
1. Connect the Powder Auto-Fill to a
20 to 90 psi (138 to 620 kPa)water
source.
2. Turn water source on.
3. Remove obstruction.
29793 011500