Filter
Top Products
28
Operating Procedures
Models QS12 & QS24
090401
Weekly Cleaning Procedures
Step 1
Loosen, but do not remove the four locating pins that
attach both sets of Gap Slide Retainers. One set is
located at the front and one set is located at the rear
of the upper platen.
Step 2
Lift the upper platen to the raised position. Remove
the four locating pins on both ends of the p laten.
Step 3
Remove both sets of the Gap Slide Retainers and Gap
Slides. Take them to the sink for washing, rinsing and
sanitizing. Wipe dry with a clean, sanitized towel.
Step 4
Re-install the Gap Slide Retainers and the Gap Slides
in their original locations.
Note: The front Gap Slide set will be marked with an
( F ) to designate the front location. The rear set will not
be marked.