Filter
Top Products
12
Installation Instructions
2. To install the bracket, place it against the wall in the mounting
location. Using a drill with 1/8” diameter drill bit, drill four (4)
1 5/8” deep pilot holes perpendicular to the screw seating
surfaces shown below. Attach the bracket to the wall as
shown with the four (4) included #12 x 1 3/4 screws.
Preparing for Installation (cont.)
Installing the Anti-Tip Bracket on the Wall
1. Determine the suitability of wall mounting the anti-tip bracket.
To use the wall mount option, the range front panel must not
be more than 27 1/2” from the wall and the bracket screws
must be able to thread into the base plate inside the wall
behind. The notches on the sides of the bracket indicated the
minimum required height of the base plate inside the wall and
that any floor covering is not too thick for proper screw thread
engagement.
To determine if the base plate is high enough:
◊ Determine the location of the range center line and front
panel when the range is in its final position based on
the product dimensions on page 5 and the actual
cabinet/cutout dimensions used for the installation.
◊ Determine and mark the required position of the anti-tip
bracket, based on the diagram above. Push the bracket
up against the wall in the mounting location.
◊ Using a pencil, make a dot next to the notches on both
sides of the bracket. Determine if the base plate is as
high at the notches by drilling test holes into the wall at
both dots with a 1/16” drill bit. Drill just deep enough to
see if the bit contacts the base plate. If the bit contacts
the base plate the location will support wall installation of
the anti-tip bracket. If you do not contact the base plate,
the wall mounting method may not be used and the floor
mounting method must be suitable, or the wall must be
modified so that the base plate is above the notches.
C
L
C
L
#12 x 1 3/4” screw,
4 places
Range front
panel
Bracket
center line
Range
center line
Back wall
11”
(27.9 cm)
Cabinet
face below
countertop
This hole lines up with
bracket center line
Top View - Location of Wall Mounted Anti-Tip Bracket
26 1/2”
(67.3 cm)
to 27 1/2”
(69.9 cm)
Wall
Anti-tip
bracket
Drywall
Notch
Base plate