Filter
Top Products
13
Installation Instructions
Removing the Oven Door
To make the range easier to move, remove the door to reduce
weight.
WARNING
• Do not attempt to disengage the hinge catches with the
door removed from the oven. The hinge springs could
release causing personal injury.
• Do not lift or carry the oven door by the handle.
1. Open the door to its fully opened position.
2. Using a screwdriver, rotate the catch over the retaining arm
on each hinge.
3. Lift the oven door to about a 15° angle from the vertical
position.
4. Hold the door with both hands just below the handle and pull
it away from the oven while continuing to lift.
Optional Backguard/Island Trim Installation
(Freestanding Model, DR30D[H] Only)
When used, the optional island trim or optional 6 or 9 inch
backguard must be installed before sliding the range into
place. Install them according to the accompanying installation
instructions.
Side Panel Removal on Model DR30DI[H]
Remove the 3 1/4” side panels if both the top and the front of the
range will be self-rimmed (see pages 7 and 8). Remove
them before sliding the range into place.
1. Remove the two screws on the side of the range and the one
just above the kick panel that hold the side panel in place.
2. To remove, slide the panel toward the back of the range, off
of the ball studs.
Door Gripping Points
Catch
Retaining arm