Filter
Top Products
19
Re-installing the Oven Door
WARNING
To avoid personal injury or damage to the door from it falling off
its hinges:
• Make sure that the notch on the bottom of each hinge rests
on top of the lower lip of each hinge receptacle before
attempting to open the oven door.
• Rotate the hinge locks toward the front of the range
immediately after installation of the door.
1. Grasp the oven door on opposite sides and hold it at a 15°
angle from the front of the oven. Slide the hinges into the
hinge openings, resting the bottom of the hinge arms on the
hinge receptacles. Continue to hold the door at a 15° angle
with one hand while pushing in on each of the bottom corners
of the door. Push until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the oven.
4. Slowly and carefully open and close the door completely to
ensure that it is properly installed.
5. Remove any packaging from inside the oven.
Installation Instructions
Cooktop Assembly
WARNING
Never attempt to operate the range’s cooktop with any of the
burner rings, burner caps or grates removed.
1. Remove the burner rings, burner caps and grates from their
shipping packages.
2. Assemble the burners and grates as shown below.
SimmerSear Burner
Assembly
Standard Burner
Assembly
Burner
ring
Burner
ring
Pin on burner
base
Igniter on
burner base
Igniter
hole
Outer burner
cap
Inner burner
cap
SimmerSear
burner
Standard
burners
Grates
Spill tray
Ridge on
bottom of
burner cap
Ridge on bottom of
on inner burner cap
Door Installation
Lower lip
of hinge
receptacle
Notch on bottom
of hinge