Filter
Top Products
15
Installation Instructions
Bare wire
connections
Loop and
spade terminal
connections
L1 terminal
L2 terminal
L1 wire
White wire
L2 wire
Strain relief
Neutral terminal
Neutral to ground
jumper link
3-wire Appliance Cord
Connection -
Where Local Code Permits
L1
Neutral
L2
10-50P Plug
5. Slide the end of the appliance cord into the strain relief from
the bottom of the box.
6. Connect the white (neutral) wire to the neutral terminal in the
box.
7. Connect the L1 wire to the L1 power supply terminal in the
box.
8. Connect the L2 wire to the L2 power supply terminal in the
box.
9. If using a 4-wire connection, connect the ground wire to
the grounding screw inside the box using a loop or spade
terminal.
10. Tighten the strain relief so that the appliance cord is held
snuggly in place.
11. Replace the range electrical access cover.
L1 terminal
L2 terminal
L2 wire
Green wire
White wire
Strain relief
Neutral terminal
Neutral to ground
jumper link removed
Grounding screw
4-wire Appliance
Cord Connection
(preferred)
L2
Neutral
Ground
L1
14-50P Plug
L1 wire