Filter
Top Products
Removing and Installing Parts 91
Installing a Media Card Reader
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your
body before you touch any of your computer’s electronic components. You can do so by touching an unpainted
metal surface on the computer chassis.
1
Follow the procedures in "Before You Begin" on page 53.
2
Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
3
Remove the computer cover (see page 59).
4
Remove the drive panel (see page 76).
5
Remove the Media Card Reader and bracket from its packaging and ensure that all of the screws
are included.
6
Gently slide the drive into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
Media Card
Reader
screws (4)