Filter
Top Products
35
V1.10
8.6. Motion Detection
8.6.1. Build-in Motion Detection
This function is applicable to DCS-900, 900W, and
G900.
【Step1.】 Configure Motion Detection
Select the Image icon to be configured. Click Detection
button from the Manu Bar. A Motion Detection window
pops up.
【Step2.】 Set Detection Areas
A red square follows mouse movement, click to place
the red square to the area of motion detection.
【Step3.】 Cancel Detection Area
Click to deselect a specified area.
【Note】The Granularity parameter described in C4.6 Motion Area
Build-in motion detection requires significant processor power. It is advised that no more then 2 Internet cameras have build-in motion
detection turned on, or you will have to carefully review hardware performance, and upgrade hardware if necessary.
8.6.2. Device Motion Detection
Please refer to your camera manual. This function is
applicable to camera other than DCS-900, 900W,
and G900.