Filter
Top Products
59
V1.10
27. How do I turn off all alarms temporally without change any configuration which
previously set?
Click the ON button to change its display to OFF. This button is located in the system control
area of the Monitor Program. After you’ve done this, all alarm settings are turned off.
28. Why no alarm message is received after Load Setting?
It is recommended that you check the alarm actions you have configured for cameras you
loaded, make sure that the alarm breach device are correctly assigned after loading the
settings.
29. Why no alarm message from sensor is received after upgrade D-ViewCam from
v1.00 to v1.10?
The Alarm Type of “Alarm Detected” in D-ViewCam v1.00 will be re-assigned to “Image Motion
Detected” in D-ViewCam v1.10, please check the sensor alarm actions you have configured in
v1.00, and re-assign the alarm action to the breach device respectively.
30. Why no alarm message is received even though all settings in the Admin Program
are correctly set?
You might have turned the alarm setting OFF in the Monitor Program. Click this button back to
ON to receive alarm messages.
31. After I’ve changed the time or date of my computer system, the D-Link D-ViewCam
alarm function does not seem to work anymore?
Please exit D-ViewCam then reboot your computer after you’ve changed your computer
system’s time and date. Then run D-ViewCam again. The alarm function should go back to
normal.
32. What will happen when my hard disk or network storage device is running out of
space?
When your hard disk’s or network storage device’s space is approaching 90% full, if you have
enabled the Recycle function, the system will automatically delete 20% of the recorded video
on your hard disk or network storage device on the first in first out basis. For complete details
on how to use this function, please refer to your User’s Manual section C4.4. To prevent losing
recorded video data, please remember to periodically back up your recorded video files and
delete the unwanted ones. For details, please refer to your User’s Manual section C8.11.
33. What format can I export the alarm report to?
This function supports the text, Microsoft Excel and Microsoft Word formats. Note that
Microsoft Word 2000 is currently not supported.