Filter
Top Products
Creating a New Wash Protocol
To create a new wash protocol header:
1. Display the main menu.
1: - - - - - - - - - -
SETUP PROGRAM
2. Use the up or down scroll keys to display the protocol number (or
use the keypad to enter the protocol number) that is to be
created:
6: - - - - - - - - - -
SETUP PROGRAM
Note: Dashes will be displayed if a protocol
has not yet been named.
3. Select PROGRAM. The name of the wash protocol is displayed
in the lower line:
Enter name
- - - - - - - - - -
4. Use the keypad to enter the protocol name (up to 9 characters)
and press ENTER. The display will read:
Password?
YES NO
Note: Refer to page 24 for instructions on
entering alphanumeric characters.
5. Select YES if the protocol is to be password protected. The
display will read:
Enter password
********
Note: If NO is selected, the Select plate
prompt (Step 7) will be displayed.
6. Enter the password, (up to eight numeric characters) and press
ENTER. The display will read:
Confirm password
********
42 Opsys MW™ User’s Guide