Filter
Top Products
Creating a New Wash Protocol
To specify a Soak (outside of a Move):
Note: A Soak can be performed either within
or outside of a Move cycle. The procedure
below describes the procedure for specifying a
soak outside of a Move cycle.
The procedure for specifying a Soak within a
Move cycle is described on page 47.
1. Scroll right to display the next selection. The display will read:
Select option
SOAK END
2. Select SOAK. The display will read:
Duration? 5
3. Enter the desired soak duration (1 to 999 seconds) using the
keypad.
Note: A soak duration ranging from 1 to 999
seconds can be entered.
4. Press ENTER The display will read:
Select option
SOAK END
54 Opsys MW™ User’s Guide