Filter
Top Products
Pump Calibration
8. If the dispensed volume is too high, decrease the pump speed
using the SETUP/CAL function (refer to page 36).
• A pump speed change of -10 units roughly corresponds to a
well volume change of -10µl.
9. If the dispensed volume is too low, increase the pump speed
using the SETUP/CAL function (refer to page 36).
• A pump speed change of +10 units roughly corresponds to a
well volume change of +10µl.
10. Repeat Steps 3-9 until fluid is dispensed with the accuracy
required. (e.g., Error less than or equal to ±5%)
Opsys MW™ User’s Guide 75