Filter
Top Products
Modifying a Wash Protocol
To modify a wash operation:
1. Select EDIT while the operation is displayed. The first step in the
operation is displayed:
Start strip? 1 Cycles
Note: The actual step that is displayed
depends upon the operation being modified.
2. Modify the operation, using the same procedures as when
creating a new wash protocol.
MOVE 1-10 1 Cycles
DELETE EDIT
Note: In the example above, the End Strip was
changed from 12 to 10. The actual values that
are displayed will depend upon the operation
being modified and the new value(s) entered.
Note: Once the move loop is modified, the
display will no longer read as shown above.
Instead, it will display the first command in the
move loop or End of Move.
3. Press ENTER to display the next step on the wash protocol.
58 Opsys MW™ User’s Guide