Filter
Top Products
Routine Maintenance Procedures
• Replace the dispense (Wash) tubing.
• Replace the aspirate (Waste) tubing.
Note: The dispense tubing and aspiration
tubing may need to be replaced more
frequently than every six months, depending
upon the frequency of use and the severity of
operating conditions.
Contact
DYNEX Technologies
for information on
replacement tubing.
• Replace the in-line hydrophobic filter.
If the system will not be used for a period of time, the system should
be flushed with de-ionized water so that buffers and/or reagents
used to wash the plates are not deposited on the Wash Head or
other components of the system.
As required maintenance:
• Pump Calibration (page 74)
68 Opsys MW™ User’s Guide