Filter
Top Products
13
RATING PLATE
This is situated on the lower front frame of the
appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on the
back or top of some models (where applicable).
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
Do not remove the rating plate from the appliance
as this may invalidate the guarantee.
GENERAL NOTES ON USING THE OVENS
We suggest that you run the oven elements for 10 – 15
minutes at 220°C to burn off any residue from their
surfaces.
The procedure should be repeated with the grill for
approximately 5 –10 minutes.
During this period an odour may be emitted, it is
therefore advisable to open a window for ventilation.
ABOUT CONDENSATION AND STEAM
When food is heated it produces steam similar to a
boiling kettle. The ovens are vented to allow some of
the steam to escape. However, always stand back
from the appliance when opening the oven door to
allow any build up of steam or heat to release.
If the steam comes into contact with a cool surface on
the outside of the appliance, e.g. a trim, it will
condense and produce water droplets. This is quite
normal and is not caused by a fault on the appliance.
To prevent discolouration, regularly wipe away
condensation and also soilage from surfaces.
COOKWARE
Baking trays, dishes etc., should not be placed directly
against the grid covering the fan at the back of the
oven.
DO NOT
use baking trays larger than 30cm x 35cm
(12” x 14”) as they will restrict the circulation of heat
and may affect performance. Advice on the effect of
different materials and finishes of bakeware is given in
‘Hints and Tips’ in the appropriate oven section.
THE COOLING FAN FOR THE CONTROLS
The cooling fan comes on immediately when the grill or
top oven is switched on and after a short time when the
main oven is in use. It may run on after the controls
are switched off until the appliance has cooled. During
the initial period the cooling fan may turn ON and OFF,
this is quite normal.
Always allow the cooling fan to cool the
appliance down before switching off at the
wall prior to carrying out any cleaning or
maintenance work.
CONTROL PANEL INDICATOR NEONS
These lights indicate whether the grill or ovens are
switched ON. In the case of the ovens, the
temperature neons also indicate when the set
temperature has been reached. The temperature neon
will go out when the oven has reached the set
temperature. It will turn on and off during cooking to
show that the oven temperature is being maintained.
If the neons do not operate as the instructions indicate
the controls have been incorrectly set. Return all
controls to zero and reset following the instructions for
the required setting.
ON/OFF PUSH BUTTON
The oven must be switched on before setting any
cooking function or programme. When the on/off
button is pressed, the cavity symbol will show in
the Main Oven electronic display.
To switch off the oven, you can press the on/off button
at any time. Any cooking function or programme
will stop, the oven light will switch off and the Main
Oven electronic display will show the time of day only.
OVEN FUNCTION CONTROL PUSH BUTTONS
(MAIN OVEN)
Push button to allow you to select the cooking
function. Each time you push this button a symbol will
come on in the Main Oven Electronic display, showing
what cooking function has been chosen.
SETTING THE LANGUAGE
1. Switch the appliance on by pressing the on/off
button .
2. Press the on/off button and the timer selector
button simultaneously.
3. Using the / buttons, select one of the
languages displayed.
4. Press the on/off button and the timer selector
button simultaneously to save the language
selected.
INTRODUCTION