Filter
Top Products
5-7
5.4.5 Filter Busy
When FILTER BUSY is displayed the MIB board is waiting on another vat to be filtered or waiting on
a computer error to clear. Wait 30 minutes to see if problem is corrected. If not, follow the instructions
below.
DANGER
Do not drain more than one frypot at a time into the built-in filtration unit to avoid
overflow and spillage of hot oil that may cause severe burns, slipping and falling.
The reset switch (see Figure 12) is used in case the
valves did not close completely. Pressing the reset
switch closes all the valves and resets the system.
It takes approximately 60 seconds to completely
reset the filter system.
NOTE: The auto top off feature and the fryer
continue to operate normally during this reset.
Figure 12
WARNING
The filter pump is equipped with a manual reset switch in case the filter motor
overheats or an electrical fault occurs. If this switch trips, turn off power to the filter
system and allow the pump motor to cool 20 minutes before attempting to reset the
switch (see Figure 13).
WARNING
Use caution and wear appropriate safety equipment when resetting the filter pump
reset switch. Resetting the switch must be accomplished with care to avoid the
possibility of a serious burn from careless maneuvering around the drain tube and
frypot.
Figure 13 Filter Pump Reset Switch