Filter
Top Products
4-5
DANGER
DO NOT operate the filter without the Power Shower in place unless unit is configured with a
rear flush option. Hot oil will spray out of the fryer and may cause injury.
4. After all oil has drained from the pot, push
the filter handle down and to the rear to
start the pump and begin the filtering
process. (For units equipped with a rear-
flush option, position the control lever to
either the Power Shower or Rear Flush
position.) There may be a slight delay
before the pump activates.
5. After the oil is filtered, close the drain
valve and allow the fryer to refill. Let the
filter run 10 to 12 seconds after bubbles
appear in the oil to clear the lines and
prevent hardening of shortening in the
lines.
WARNING
The filter pump is equipped with a manual reset switch in case the filter motor overheats or
an electrical fault occurs. If this switch trips, turn off power to the filter system and allow the
pump motor to cool 20 minutes before attempting to reset the switch.
Push filter
handle down and
to the rear.
Push drain handle
to the left to close.