Filter
Top Products
6-10
6.7 Replacing the Controller or Controller Wiring Harness
1. Disconnect the fryer from the electrical supply and remove the two screws in the upper corners
of the control panel. Swing the panel open from the top, allowing it to rest on its hinge tabs.
2. Disconnect the wiring harness from the back of the controller and, if replacing the harness,
disconnect it from the interface board (see photo on preceding page.
3. Disconnect the ground wire from the controller, and remove the controller by lifting it from the
hinge slots in the control panel frame.
4. Reverse the procedure to install a new controller or wiring harness.
Fuse
Interface Board
Connection
Ignition Modules
Controller
Connection
Wiring Harness