Filter
Top Products
36
Drying program
With the drying program, you can dry the cooking
compartment after cleaning or after steaming.
The drying program takes 20 minutes.
Starting the drying program
1 Remove accessories from the cooking
compartment. Wipe out the cooking
compartment. Thoroughly remove residues of
cleaner. Close appliance door.
2 Set the function selector to S. Select the drying
program with the rotary selector.
3 The j symbol is displayed. Confirm with ™.
4 The drying time of 20 minutes appears. Touch I to
start. The drying time elapses on the display. The
lamp in the cooking compartment stays off.
5 A signal sounds after 20 minutes. A message
appears in the display. Confirm with ™.
The drying program has ended. Allow the appliance to
cool down. Then polish the cooking compartment and
the panel with a soft cloth.
Descaling program
To keep your appliance in good working order, you
have to descale the cooking compartment regularly.
Especially the area behind the side plate should be
descaled regularly. Depending on water hardness and
frequency of use, you will need to descale your
appliance more often, especially for appliance
versions with enameled cooking compartments.
Be careful not to scratch the oven interior when
removing the side plate. Ensure that no small parts fall
into the base strainer. Tip: put a kitchen cloth over the
oven base.
Descaler
For descaling, use only the liquid descaler
recommended by after-sales service (order # 667025
from after-sales service or in the online shop). Other
descaling agents can cause damage to the appliance.
9 CAUTION
Surface damage
Wipe off descaler immediately with water if it
reaches the door seal, the front or other
sensitive surfaces.
9 CAUTION
Surface damage
Do not use harsh or abrasive cleaning agents or
objects for descaling.
Notes
‒ If using the descaling and neutralizing filter
(special accessory GF 111 100)
:
clean and descale the cooking compartment each
time you change the filter cartridge. If it is not
necessary to descale the cooking compartment,
clean it with the oven interior care agent.
‒ We recommend, in combination with the descaler,
our oven interior care agent for stainless-steel
care and to neutralize descaler residues (order #
667027 from after-sales service or in the online
shop). It contains a care agent, a soft non-scratch
sponge and a lint-free cloth.
Starting the descaling program
1 Set the function selector to S. Select the
descaling program with the rotary selector.
2 The ‘ symbol is displayed. Confirm with ™.
Follow the instructions that are shown in the
display.
3 To remove the side plate detach the left slide-in
rails (see section entitled Removing slide-in rails).
Detach the grease filter in the upward direction.
Undo the forward bolt with a socket wrench
(SW 13). Remove the side plate. Confirm with ™.
4 Place the side plate separately in the sink and
spray on descaler Leave to act for a few minutes.
Rinse thoroughly with plenty of water.
9 CAUTION
Do not let the descaling solution come into
contact with surfaces that are sensitive to
acid (e.g. marble worktops)!
5 Spray descaler onto the areas in the cooking
compartment where limescale has developed and
leave to act for 1 - 3 minutes. Confirm with ™.
6 Repeat the descaling process if necessary.
7 Thoroughly rinse off the descaler. Be sure to
clean the door seal again with a clean, damp
'U\LQJSURJUDPPH
_