Filter
Top Products
DRAIN PUMP (KA7E ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove Right Side Cover.
2. Remove WASH PUMP (KA7E ONLY).
3. Disconnect wires from drain pump.
4. Remove screws securing pump to bracket.
5. Loosen both hose clamps.
Fig. 93
6. Pivot pump and pull out of oven.
Fig. 94
7. Reverse procedure to install.
DRIVE MOTOR ASSEMBLY
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
TSB1400 KA7E - LEAKS AT DRIVE ARM GASKET
DURING WASH CYCLE.
TSB 1383 ROTISSERIE OVENS HR5E, HR7E AND
KA7E NEW DRIVE MOTOR ASSEMBLIES. See
Multimedia section in TIS.
TSI HR7E AND KA7E ROTISSERIE OVEN ROTOR
CRANK ARM DISENGAGING FROM ROTOR. See
Multimedia section in TIS.
1. Check that crank arm is stopped pointing to the
side that has the interior light (or pointing away
from motor). If it is not, apply power to unit and
use the rotate switch to start and stop drive motor
when crank arm is in the proper position. Then
disconnect power.
NOTE: If there is a motor malfunction and you cannot
position the crank arm, you will be able to manually
put the crank arm in the proper position after you
remove the motor and speed reducer. Refer to DRIVE
MOTOR, SPEED REDUCER AND GEARBOX.
Fig. 95
2. Remove Right Side Cover.
3. Remove screws securing gasket bracket and
gasket.
NOTE: Replace washers and gasket with new ones
on reassembly.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
Page 29 of 72 F25294 Rev. A (0412)