Filter
Top Products
WATER LEVEL SENSOR (KA7E
ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove
Right Side Cover.
2. Remove wire attached to sensor.
3. Unscrew sensor and remove from oven.
PARTS REMOVED FOR VIEW
4. Reverse procedure to install.
CHEMICAL SENSOR (KA7E ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Oven cleaners are corrosive and
can cause chemical burns. Rubber gloves, goggles
and protective clothing are required. Read and follow
the instructions for the oven cleaner.
1. Remove Right Side Cover.
2. Remove wire attached to sensor.
3. Loosen hose clamps and work hoses off sensor.
Fig. 75
4. Reverse procedure to install.
WASH PUMP RELAY (KA7E ONLY)
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove Right Side Cover.
2. Use small screwdriver to pry out release tab, lift
front of relay and disengage rear of relay from din
rail.
Fig. 76
3. Identify and disconnect wires.
4. Reverse procedure to install.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
F25294 Rev. A (0412) Page 24 of 72