Filter
Top Products
Fig. 96
NOTE: Gasket bracket may not be able to be
removed until gear box mounting screws are
removed.
4. Identify and remove motor wires from terminal
block.
A. Insert jeweler screwdriver or similar small
tool into holes to release spring tension and
pull wires out.
NOTE: The following picture shows the terminal block
disassembled to illustrate how the tool is inserted to
release the wire.
Fig. 97
5. Remove four screws securing pump mounting
box and allow box to slide down for access to
motor support screws.
KA7E - PREVIOUS CONSTRUCTION SHOWN
6. Remove four screws, washers and nuts securing
assembly to motor support.
Fig. 99
7. Pivot motor away from oven and work crank arm
out of hole in side wall.
Fig. 100
8. Remove gasket bracket and gasket if not already
removed.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
F25294 Rev. A (0412) Page 30 of 72