Filter
Top Products
KA7E PREVIOUS CONSTRUCTION WITH GREY
WATER/SUMP PERISTALTIC SHOWN ON LEFT
2. Disconnect hose ends and work hose out of
pump.
Fig. 85
3. If rollers need to be removed, use a screwdriver
and release both sides of retaining clamp.
Fig. 86
4. Pull roller assembly off shaft.
Fig. 87
5. Install new hose. Work hose around cavity and
manually turn rollers as hose is positioned. Make
sure hose clamp is in cutout to hold hose in
position.
Fig. 88
6. Install face plate.
7. Install hose clamps and connect hoses. Trim
discharge hose length if needed for proper fit.
8. Complete reversing procedure to install.
9. Verify that pump is working properly as outlined
under SERVICE MODE - PROGRAMMING AND
DIAGNOSTICS.
KA SERIES ELECTRIC ROTARY OVENS - REMOVAL AND REPLACEMENT OF PARTS
Page 27 of 72 F25294 Rev. A (0412)