Filter
Top Products
Fig. 14
7. Route power cord through stand up into oven and
connect to terminal block.
8. Proceed to Tether Bracket and Oven Mounting to
Stand (KA7E, KA7EM).
Tether Bracket and Oven Mounting to Stand
(KA7E, KA7EM)
1. Ensure that tether bracket is installed.
A. The bracket must be installed along with
one of the swivel casters to a corner as
shown using the caster hardware provided.
The remaining open hole in the center of the
tether bracket is to be used to secure one
end of the tether (locally supplied chain,
cable, etc.). The other end of the tether is to
be secured to an anchoring point in the wall
or floor when oven installation is complete.
Make sure that during oven movement, no
stress is applied to the flexible electrical
conduit(s).
Fig. 15
2. Using holes in oven's caster mounting plate,
secure oven to stand using 4 screws and 4
washers provided with stand accessory. Install
washers such that bolt does not slip through.
Fig. 16
3. Install all removed covers.
4. Continue with installation per Instructions
Manual.
KA SERIES ELECTRIC ROTARY OVENS - GENERAL
Page 9 of 72 F25294 Rev. A (0412)