Filter
Top Products
Fig. 7
11. Install water valve onto bracket on new utility
plate (supplied with stand).
Fig. 8
12. Install new utility plate onto oven using screws
removed earlier.
13. Install drain plug removed earlier.
14. Install new hoses supplied with oven and route
down into base.
Fig. 9
15. Route water supply through the bottom of the
stand and connect. (Fittings mate to ¾ inch male
hose bib, not supplied.)
16. Route water drain through the bottom of the
stand and connect. (Fittings mate to 1 inch
female NPT, not supplied.)
17. Route chemical-in and grease-out hoses down
through bottom of machine into stand. Connect
hoses to grease vessel and chemical container.
18. Route power cord thru base into oven and
connect to terminal block.
19. Proceed to Tether Bracket and Oven Mounting to
Stand (KA7E, KA7EM).
KA7EM with Grease Assist (ML-137710,
ML-137713)
1. Remove Right Side Cover.
2. Remove electric power cord blank. Install power
cord restraining fitting (not supplied) in the proper
hole E1.
Fig. 10
KA SERIES ELECTRIC ROTARY OVENS - GENERAL
Page 7 of 72 F25294 Rev. A (0412)