Filter
Top Products
GLASS POSITIONING
Check the following to improve opening or clos-
ing of the case front glass.
1. Has the case been leveled according to
preceding paragraphs?
2. Is the glass handle installed correctly?
Verify the glass is bottomed out the length of the
handle. A bowed handle indicates the glass may
not be bottomed out at the center of the handle.
The handle must be removed before it can be
repositioned. The handle is held in place with
silicone which must be completely removed
from the handle and the glass. Remove the
handle by pulling it away from the glass (do not
use tools to pry this loose). A damaged or bent
handle must be replaced. Apply new silicone
into the handle and firmly press onto the glass.
3. Is the glass seated in the clamp hardware
correctly?
Verify glass is bottomed out in clamp hardware.
If the glass is not bottomed out in the clamp
hardware it can be re-positioned as follows:
A. Remove the glass and clamp hardware from
the case by opening the glass and loosening
set screws in hinge, (Metric 3 millimeter set
screws).
B. Slide the glass and clamp hardware to the
side out of the hinges and lay them on an
appropriate work surface.
Note: adjacent glass must be closed.
C. Loosen the 8 set screws on the underside of
the clamp hardware.
D. Push the clamp hardware onto the glass until
bottomed out.
E. The clamp hardware must overhang the glass
by an equal amount on each side.
F. Tighten set-screws and re-install on case.
P/N 0420057_B 1-5
Service Merchandisers
HUSSMANN CORPORATION, Bridgeton, MO 63044-2483 U.S.A.