hussman P/N 0420057_B Refrigerator User Manual


 
SHIPPING DAMAGE
All equipment should be thoroughly examined
for shipping damage before and during unload-
ing. This equipment has been carefully inspected
at our factory. Any claim for loss or damage
must be made to the carrier. The carrier will
provide any necessary inspection reports and/or
claim forms.
Apparent Loss or Damage
If there is an obvious loss or damage, it must be
noted on the freight bill or express receipt and
signed by the carrier’s agent; otherwise, carrier
may refuse claim.
Concealed Loss or Damage
When loss or damage is not apparent until after
equipment is uncrated, retain all packing materi-
als and submit a written request to the carrier for
inspection, within 15 days.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious person-
al injury could occur. Merchandisers
ARE NOT
STRUCTURALLY DESIGNED TO SUPPORT EXCESSIVE
EXTERNAL LOADING
such as the weight of a
person. Do not place heavy objects on the case.
MERCHANDISERS SHIPPED
WITH END INSTALLED
If the case was shipped with the end installed,
two long bolts were used to hold the shipping
brace to the end. If the shipping bolts are re-
inserted after removing the brace, they will
extend into the product area. Therefore, be sure
to replace these bolts with the shorter bolts
provided. Refer to the detailed information
provided in the separate End Kit Instruction
shipped with each end.
Note: Be careful not to damage the factory
installed end while moving the case. Make sure
that tools are positioned past the end and beneath
the merchandiser’s support bar.
SHIPPING BRACES
Move the fixture as close as possible to its per-
manent location and then remove all packaging
and shipping braces. Check for damage before
discarding packaging. Remove all separately
packed accessories such as kits, and shelves.
Remove all nut retainers used with shipping
braces. NSF certification requires the use of
ANSI Standard nuts and bolts with not more than
two (2) threads showing after installation.
SHIPPING RIDER
Each case is shipped on a rider to protect
factory-installed legs, and to make positioning
the case easier. Remove the rider after the case
has been positioned.
Note: Once the rider is removed, the case must
be lifted –NOT PUSHED– to reposition.
1-2 INSTALLATION
P/N 0420057_B
U.S. & Canada 1-800-922-1919 • Mexico 1-800-522-1900 • WWW.HUSSMANN.COM
Do NOT remove shipping braces until
the merchandisers are positioned for
installation. Frames may be damaged.
NOTICE
Do not stand or walk on top of case
because falling off could
cause serious personal injury.
WARNING
!