Filter
Top Products
19
2 Preparation
T Press the ‘Espresso’ button.
Preparation starts. The preset amount of water for espresso
flows into the cup. Preparation stops automatically.
‘Please
select product:’
appears on the display.
It is easy to make permanent settings for the amount of water for all
speciality coffees and hot water according to the cup size. Adjust the
amount once as shown in the following example. Every time you
prepare a drink in the future, this amount of water will be dispensed.
The permanent settings for adapting the amount of water to the cup
size for all speciality coffees and hot water follow this model.
Example:Proceed as follows to permanently set the amount of water
for one coffee.
Precondition:
‘Please select product:’ is displayed.
T Place a cup under the coffee spout.
T Press and hold the
‘Coffee’ button.
‘Coffee’ and the fill volume are displayed.
T Hold the
‘Coffee’ button down until ‘Enough water? Press
button’
appears.
T Release the
‘Coffee’ button.
Preparation starts and the coffee flows into the cup.
T Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
‘Saved’ appears briefly on the display. The
set amount of water for one coffee is permanently stored.
‘Please select product:’ appears on the display.
E You can alter this setting at any time by repeating the above
procedure.
E You can also permanently set the amount for all speciality cof-
fees, hot water and milk in programming mode (see Chapter4
‘Permanent settings in programming mode – Product set-
tings’).
Permanently setting the
amount of water for the
cup size