Filter
Top Products
Spin Grinding
NOTE
When discussing spin grinding, any reference
to the carriage or its associated parts means
the reel carriage, located to the right as viewed
for the operator’s side.
1. Open front canopy and adjust wheel head away
form work table bars by turning infeed screw hand
wheel counter clockwise, bringing wheel head
towards operator. Figure 3-1
Refer to Figure 3-2 and 3-3:
2. Slide limit stops to each end of the stop rail.
3. Close the front canopy and open the rear canopy.
4. Securely attach the mounting brackets to the reel
unit.
5. Place the reel unit into the grinder making sure
the mounting brackets are fitted properly and
sitting firmly on the work table bars. Leave the
mounting bracket bases loose in the work table
bars. Figure 3-4
13
Infeed Screw Hand Wheel
Figure 3-1
Left Limit Stop
Figure 3-2
Right Limit Stop
Figure 3-3