Filter
Top Products
6. Manually move grinding carriage left and right
making sure there is ample clearance between the
stone and the end of the reel blades. (It may be
necessary to reposition the reel unit slightly.)
When satisfied that the grinding wheel clears the
reel unit at both ends, tighten the brackets. Figure
3-5.
There are two ways to make reel adjustments:
A. The grinder’s movable base is used if the bed-
knife is adjusted to the reel.
B. The reel unit’s own adjusters may be used if
the reel to bedknife adjustment is made by
moving the reel to the knife.
Refer to Figure 3-6 and 3-7:
Manually turn traverse micro switch arm (the white ny-
lon rod) to the left. Move reel grinding carriage to the
left of the reel unit making sure the grinding wheel
clears the end of the reel blades. Keeping the carriage
in this position slide the limit stop to the right until the
actuating screw throws the traverse micro switch arm
to the right. Tighten the handle on the center limit stop.
Set the right limit stop in the opposite manner.
14
Micro Switch Turned to the Left
Figure 3-6
Micro Switch Turned to the Right
Figure 3-7