Filter
Top Products
SECTION 5—TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Electric motors won’t start Master button “off” position Twist master button clockwise.
It should “pop up”
Spin motor won’t start Safety switch on hood not Close canopy
engaged
Pump runs but doesn’t Water level low Add water
pump water
Valve off Open valve
Suction screen clogged Pull tank out, clean suction
screen on pump shaft
ONLY QUALIFIED ELECTRICIANS SHOULD
SERVICE THIS AREA OF THE GRINDER.
All electric motors are shipped with thermal overload
switches in the electric panel, found in the bottom of
the grinder. It may be necessary to open the front
cover and reset the appropriate switch. For further
assistance, contact you Locke Turf Dealer.
DANGER
26