Filter
Top Products
Sharpening Bedknives
1. Install tool bar assembly on work table. Mount the
bedbar with “leading edge” or “front face” of bed-
knife up on the tool bar and tighten the “L” bracket
clamping bolts. Figure 3-18
NOTE
The two (2) location brackets can be relocated along
the toolbar to accommodate bed bars of varying length.
2. Make sure the back of the bedknife is flush with
the key stock. Do not place bedbar screws on key
stock. This will result in improper grinding of the
bedknife. Figure 3-19
NOTE
The tool bar assembly is supplied with spacer blocks
of three different thickness and “L” brackets of two (2)
different lengths. Use these to adjust the height of the
bedknife assembly to provide correct access for
sharpening. Figure 3-2
3. Place the “Angle Finder” on top of the tool bar
and set the desired angle for grinding. Refer to
the reel manufacturer’s recommendations for the
proper angle. Feel free to “scribe” your own
marks for quick reference. Figure 3-21
20
“L” Brackets
Figure 3-18
Bedknife Spacer Blocks and “L” Brackets
Figure 3-20
Bedknife Secured with “L” Brackets
Figure 3-19
Grinding Angle Adjustment
Found with Angle Finder
Figure 3-21