Filter
Top Products
Disassembly Procedures
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
WARNI NG
!
16021668 Rev. 0 24 ©2002 Maytag Appliances Company
Magnetron Thermal Fuse
NOTE: Thermal fuse is not resettable.
1. Disconnect power to oven and remove control panel,
(see "Control Panel" procedure).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" procedure).
3. Remove outer case, (see "Outer Case" procedure).
4. Disconnect and label wire terminals.
5. Remove screw securing thermal fuse to cooling fan.
6. Replace and reassemble in reverse order.
Magnetron Thermal Fuse
Fan Moto
r
Humidity Sensor
The sensor is a plug-in device located in the air exhaust
duct.
Humidity Sensor Removal
1. Disconnect power to oven and remove control panel,
(see "Control Panel" procedure).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" procedure).
3. Remove outer case, (see "Outer Case" procedure).
4. Remove screws securing sensor to air duct.
5. Disconnect wire terminal plug and replace with new
sensor.
6. Reassemble in reverse order.
Oven Thermostat
The oven thermostat is on the air duct assembly.
Thermostat is a resettable thermostat.
1. Disconnect power to oven and remove control panel,
(see "Control Panel" procedure).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" procedure).
3. Remove outer case, (see "Outer Case" procedure).
4. Disconnect wire terminals from oven thermostat.
NOTE: On ACO15* and MMV5156* oven thermostat is
used as magnetron thermal fuse as well.
NOTE: On ACO18*, JMV8196*, MMV4184*, and
MMV5186* lift upward on left rear corner of air
duct to release oven thermostat.
5. Replace and reassemble in reverse order.