Filter
Top Products
WARNI NG
!
To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.
Disassembly Procedures
©2003 Maytag Appliances Company 16021875 Rev. 0 17
Oven Sensor
1. Turn off power to unit
2. Open oven door or remove oven door, see “Door
Removal”.
3. Remove screws securing sensor to top right rear
corner of oven cavity.
4. Pull sensor forward, manuver wires through
insulation to disconnect wire plug connector.
5. Reverse procedure to reinstall sensor.
Bake Element
1. Turn off power to unit.
2. Open oven door and remove screws securing unit to
the wall.
3. Remove oven from cutout opening.
4. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
5. Remove screws securing access element panel.
6. Remove screws securing element panel.
7. Disconnect wire terminals from bake element.
8. Remove screws securing element support bracket.
9. Gently pull element support bracket out.
10.Remove screws securing bake element to support
element bracket.
11.Reverse procedure to reinstall bake element.
Broil Element/Broil Element Reflector
1. Turn off power to unit.
2. Open oven door or remove oven door, see “Door
Removal”.
3. Remove screws securing broil element reflector to
top of oven cavity.
4. Pull front of broil element reflector down and forward
to allow disconnection of terminals on each element
leg.
5. Remove rivets securing broil element brackets to
broil element reflector.
6. Reverse procedure to reinstall broil element.
NOTE: Use rivets to fasten broil element brackets to
broil element reflector.
Convection Heating Element
1. Turn off power to unit.
2. Open oven door or remove oven door, see “Door
Removal”.
3. Remove screws securing fan cover to rear of oven
cavity.
4. Remove screws securing convection heating
element to rear wall of oven cavity.
5. Pull element forward to expose wire connections for
disconnection.
6. Reverse procedure to reinstall convection heating
element.
Convection Fan Blade
1. Turn off power to unit.
2. Open oven door or remove oven door, see “Door
Removal”.
3. Remove screws securing fan cover to rear of oven
cavity.
4. Using an adjustable wrench, and turning clockwise,
remove the nut in center of convection fan blade.
(Nut is Left Hand Thread).
5. Remove fan blade from D stem motor shaft.
NOTE: Behind fan blade is a washer and C clip on
motor shaft which must be in position for
correct reassembly. (To prevent Fan Blade
hitting cavity).
Convection Fan Motor
1. Turn off power to unit.
2. Open oven door and remove screws securing unit to
the wall.
3. Remove oven from cutout opening.
4. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
5. Remove convection fan blade and spacer washer,
see "Convection Fan Blade" procedure.
6. Remove access fan panel from outer wrapper cover.
7. Disconnect and label wires from convection fan
motor.
8. Remove screws securing convection fan motor
assembly to convection motor mounting bracket.
9. Reverse procedure to reinstall.
Automatic Oven Door Latch Assembly
1. Turn off power to unit.
2. See “Control Panel” for removal.
3. Disconnect and label wire terminals.
4. Remove screws securing latch assembly to chassis.
5. Reverse procedure to reinstall door latch assembly.
Door Plunger Light Switch
1. Turn off power to unit.
2. Remove control glass panel, see “Control Panel”.
3. Squeeze metal tab and push switch outward to gain
access to wire terminals.
4. Label and disconnect wire terminals from switch.
5. Reverse procedure to reinstall.