Filter
Top Products
B—6 16021875 Rev. 0 ©2003 Maytag Appliances Company
Adjusting Oven Temperature
Oven temperature has been factory calibrated and tested.
In unlikely event that oven consistently overcooks or
undercooks food, oven temperature can be adjusted.
1. Press BAKE pad.
2. Press
+
o
until an oven temperature greater than
500°F shows in display.
3. Immediately press and hold BAKE pad until "00"
appears in display, approximately 5 seconds.
4. To decrease oven temperature (for cooler oven), press
r
-
until negative numbers appear. Oven can be
adjusted from 05° to 35° lower. To avoid over-adjusting
oven move temperature -5° each time.
5. To increase oven temperature (for a warmer oven)
press
+
o
until positive number’s appear. Oven can be
set from 05° to 35° higher. To avoid overadjusting
oven, move temperature 5° each time.
6. Press OVEN CANCEL pad. Temperature adjustment
will be retained even through a power failure.
Programming Instructions—ERC for AOES3030
Service Tones and Codes
Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows an “F-code” in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record “F-code” shown.
• See, DIGIT FAILURE DISPLAY in “ERC Warnings
and Failure Codes” section.
2. Disconnect electrical supply.
• Pressing OVEN CANCEL pad or disconnecting
electrical supply may eliminate “F-code”. If failure
continues, contact an authorized servicer.
3. Contact an authorized servicer to check range.