Filter
Top Products
PROGRAMMING
25
of 90
“REFRIG X” - Refrigeration Control Override Routine
This function is used to override “REFRIG”, if it is being used. “REFRIG 0” = disabled and “REFRIG 1” =
enabled.
Press key number 4 and “#” will start flashing.
Press key number 2 or 3 to scroll between “REFRIG 0” and “REFRIG 1”.
Press key number 4 with the display showing the setting you wish to use.
Display will return to “REFRIG X”.
Press key number 1 to return to “OVERRIDE”.
Press key number 2 to scroll to “RVNDMECH”.
“RVNDMECH” - REMOTE VEND MECHANISM ROUTINE
This function is used to activate the Universal Satellite Device Control routine.
Press key number 4 to enter routine. If the controller detects a device responding to the remote vend mechanism
address (USD address #3,50H), the vend request commands for this device will be controlled by the following
parameters.
“STRT TIM” - Start Time Setting Routine
This function is used to set the day(s) and time to start the routine.
Press key number 4 and “STRT DAY” will show on the display.
“STRT DAY” - Day of week to start setting
Set this feature using instructions for “SELBLCK1”, “STRT TIM”, “STRTDAY”.
“STRT HR” - Start hour and minute settings
Set this feature using instructions for “SELBLC1”, “STRT TIM”, “STRT HR”.
“STOP TIM” - Stop Time Setting Routine
This function is used to set the day(s) and time to stop the routine.
Press key number 4 and “STOP DAY” will show on the display.
“STOP DAY” - Day of week to stop setting
Set this feature using instructions for “SELBLCK1”, “STOP TIM”, “STOP DAY”.
“STOP HR” - Stop hour and minute settings
Set this feature using instructions for “SELBLCK1”, “STOP TIM”, “STOP HR”.
“SELECT” - Selection Setting Routine
This feature is used to set the selection(s) which will be affected by the Remote Vend Mechanism routine.
Press key number 4 and “SEL A1 #” will be displayed, where # is the current setting for the selection
number displayed. 0 = disabled, 1 = enabled.
Press key number 2 to scroll to the select button number you desire to change.
Press key number 4 with the select button number showing you wish to change (i.e. SEL A1 #) and the #
will start blinking.
Press key number 2 or 3 to scroll between “SEL A1 0” and “SEL A1 1”.
Press key number 4 with the display showing the setting you wish to use.
Display will return to “SEL ## #”.
Press key number 1 to return to “SELECT”.
Press key number 2 to scroll to “VND RATE”.