Filter
Top Products
INSTALLATION & SETUP
4
of 90
INSTALLATION & SETUP
The Dixie-Narco Coca-Cola Glass Front Vender is
designed utilizing the latest technology.
RECEIVING INSPECTION
DO NOT STORE THE VENDER OUTSIDE.
THIS MACHINE IS FOR INDOOR USE ONLY.
Upon receipt, inspect the vender for any shipping
damage. If there is any damage have the driver
note the damage on the bill of lading and notify
Dixie-Narco. Although the terms of sale are FOB
shipping point, which requires the consignee to
originate shipping damage claims, Dixie-Narco will
gladly help if you must file a claim.
UNPACKING THE VENDERS
Remove the stretch wrap fiberboard edge protectors
and corrugated front protector from the outside of
the vender.
DO NOT STORE THE VENDER
OUTSIDE WITH THE STRETCH
WRAP ON. THIS COULD CAUSE
THE STRETCH WRAP TO BOND
TO THE VENDER’S SURFACE,
WHICH COULD DAMAGE THE
FINISH.
Remove the shipping boards from the bottom of the
vender. The shipping boards are attached by the
leveling legs. To avoid unnecessary damage to the
leveling legs or base, remove shipping boards by
using a 1 – ½ inch socket type wrench to unscrew
the leveling legs. Be sure to replace the legs after
removing the shipping boards. Once the vender is
unpacked, check the service area for any additional
parts, price/product labels, service/operation
manual, or other information concerning factory-
equipped accessories such as coin mechs and
validators.
WARNING: TO AVOID THE
POSSIBILITY OF A FIRE HAZARD, DO
NOT STORE ANYTHING OR ALLOW
DEBRIS OF ANY KIND TO
ACCUMULATE IN THE BOTTOM OF THE
SERVICE AREA, IN AND AROUND THE
REFRIGERATION COMPARTMENT OF THE
CABINET, OR IN FRONT OF THE EVAPORATOR
AND CONDENSER COILS.
ELECTRIC POWER NEEDED
Refer to the cabinet serial number plate to determine
the proper voltage and frequency the machine
requires (domestically this requirement is 120 Volts,
60 Hertz). The cabinet serial plate also indicates the
Amperage of the vender. The vender must be
plugged in to its own properly rated single phase,
alternating current outlet with its own circuit
protection (fuse/circuit breaker).
DO NOT USE AN EXTENSION CORD.
GROUND THE VENDER
The vender is equipped with a three wire power
supply cord and MUST be plugged into a properly
grounded outlet.
DO NOT REMOVE THE GROUND
PIN OR IN ANY WAY BYPASS,
MODIFY, DEFEAT, OR DESTROY
THE GROUNDING SYSTEM OF
THE VENDER.
If the outlet will not accept the power cord plug,
contact an electrician to install a proper AC outlet.
FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY
SUBJECT THE USER TO THE RISK
OF INJURY OR ELECTRICAL
SHOCK WHICH CAN BE SERIOUS
OR FATAL.
COIN CHANGERS & OTHER
ACCESSORIES
The vender must have an MDB coin changer
installed and can have an MDB bill acceptor
installed. If the MDB coin changer and other MDB
accessories are not factory installed, refer to the
instructions received from the manufacturer of the
MDB coin changer and other MDB accessories for
proper set-up and installation.
The Vender will support the following MDB coin
changers:
Multi-Drop Coin Mech (Domestic)
Coinco 9302GX Conlux CCM-5G
Mars TRC6510
Mars TRC 6512
The Vender will support the following MDB bill
validators:
Multi-Drop Bill Validators (Domestic)
Coinco BA30B, BA50, MAG30, MAG50
Mars VN2512, VN2502, VN2312
Conlux NBM-3000 Series, MKA-2141-11
Ardac 5500 Series