Filter
Top Products
Evaporate residual moisture
If there is still water in the steam
injection system at the end of a
programme or if the programme is
cancelled, you will be prompted to
evaporate the residual moisture.
If you confirm the prompt immediately
with OK, the oven will heat up to
approx. 150 °C and the residual water
will evaporate.
How long this takes will depend on the
amount of water in the system.
If you select "Cancel", the evaporation
of the residual water will not start imme-
diately.
However, you will then only be able to
run functions and Automatic
programmes without Moisture plus.
The evaporation of the residual water
process must be carried out before you
can use an Automatic programme with
Moisture plus or the Moisture plus
function.
Descaling
The oven will need to be descaled
depending on the number of cooking
programmes using Moisture plus which
have been run and the amount of water
taken into the oven for these.
The frequency of descaling also
depends on the water hardness level in
your area.
A message to tell you to descale the
appliance will appear in the display.
You can start the descaling process at
any time by selecting "Descale" in the
main menu.
If you do not carry out the descaling
process when the prompt to descale
the oven appears, you will only be able
to run functions and Automatic
programmes without Moisture plus.
See "Cleaning and care" for more
information about descaling.
Moisture plus
45