... after moving house the appliance
no longer switches from the heating
up phase to the cooking phase.
Altitude affects the boiling point of wa
-
ter. The appliance must be re-set to
take into account the different water
boiling point in its new location (see
"Cleaning and heating up for the first
time".)
... during operation an unusually
large amount of steam escapes or
steam escapes from parts of the
steam oven where it does not
usually.
Check whether
– the door is closed properly.
– the door seal is fitted correctly. If
necessary, press it in all the way
round the door to make sure it is
fitted evenly.
– the door seal is damaged, e.g.
cracks can be seen. The seal must
be replaced with a new one.
If this does not solve the problem, call
the Miele Service Department.
... the p symbol appears in the
display and an audible tone may
sound.
Check whether
–
the water container has been pushed
right into the appliance so that it
connects.
–
there is sufficient water in the water
container. The water level must be
between the two markings.
... when the appliance is switched on,
the k symbol and a number between
1 and 10 or
"0:22h" appear in the display and the
k symbol flashes.
The appliance needs to be descaled.
Proceed as described in "Descaling" in
"Cleaning and care".
... F05 or F06 appears in the display.
Switch the appliance off and call the
Service Department.
... F20 appears in the display.
The appliance does not heat up.
– First of all, check whether the water
container has been pushed right into
the appliance so that it connects.
Then switch the appliance off and
then back on again.
– If the fault occurs again, lightly
lubricate the coupling seal on the
water container with silicone grease,
as described in "Coupling seal".
If the appliance still will not start, switch
it off and contact the Miele Service
Department.
... after a period of time, the door
makes a noise when it is opened and
closed.
Lubricate the hinges with the silicone
grease supplied.
Problem solving guide
43