Filter
Top Products
Starting a pyrolytic process
^
Take all accessories out of the oven.
^
Select the Pyrolytic ^ function.
Py I
PY I will appear in the display. The
number will start flashing.
Use the V or W sensor to scoll between
PY I, 2 and 3.
^ Start the pyrolytic process required.
^ Touch the OK sensor.
Pyrolytic cleaning will commence.
Py I
0
The door will lock. The 0 symbol
shows that the door lock has been
activated. The oven heating will switch
on.
I:53
h
m TS0
V
The duration of the cleaning
programme can be seen in the display
when triangle V is below the T
symbol.
You can set a finish time for the
pyrolytic process during the first five
minutes after starting the programme,
for example, to take advantage of
cheaper night electricity tarifs. To do
this:
^ Call up the S (Finish) symbol and
use the W sensor to change the finish
time.
You can change the finish time if you
wish at any time up until the
programme starts.
At the end of pyrolytic cleaning
process
–
PYE will appear in the display.
–
the S symbol will start flashing.
–
a buzzer will sound, if the buzzer is
switched on, see "Settings % –
P:2".
^
Turn the function selector to "0".
The buzzer will stop and the symbols in
the display will go out.
Cleaning and care
64