Filter
Top Products
Time display
Before the program starts, the display
shows the runtime of the selected
program in hours and minutes. The
remaining runtime is displayed during
the program.
Symbols will appear to indicate the
stage of the program:
1 Pre-wash
8 Main wash
% Interim rinse
( Final rinse
G Drying
O End (Finished)
The runtime that is displayed may vary
for the same program. It depends on
the temperature of the incoming water,
the reactivation cycle, the quantity of
dishes, and other factors.
When a program is selected for the first
time, the display shows an average
program runtime for warm water.
The runtimes change if the electrical
connection is changed.
Standby
A few minutes after the last time a
button has been pressed or a few
minutes after the end of the program
the commercial dishwasher will switch
into Standby mode to save energy. The
display and the indicator lights will turn
off and only the - indicator light will
flash slowly.
^
Press the - button to switch the
display and indicators back on.
If the commercial dishwasher is not
turned off after the program ends, after
a few minutes in standby mode it will
turn off completely (see "Settings menu
- Optimizing Standby").
If Refill salt, Refill rinse aid or a fault
is displayed, or while a program is
running, the commercial dishwasher
will not switch to Standby mode.
The refill messages can be turned
off to let the commercial dishwasher
go into Standby mode without first
refilling (see Settings menu - Refill
messages).
However, fault messages cannot be
turned off.
Operating the commercial dishwasher
40