Filter
Top Products
Checking the filters in the
wash cabinet
The filter combination in the base of the
wash cabinet captures large dirt
particles from the wash water. This
prevents them from reaching the
circulation system and re-entering the
cabinet through the spray arms.
,
This commercial dishwasher
must not be used without all the
filters in place!
Collection of coarse particles may
cause the filters to clog over time. The
dirtier the dishware the sooner the
filters need cleaning.
The message
Check filters is
factory-set to appear in the display after
every 50 program cycles.
You can turn off the filter check or set
the frequency to 30 to 60 program
cycles (see Settings menu - Filter
check).
^
Check the filter combination.
^
Clean it, if necessary.
^
Then press the centre button to
confirm the message.
The last selected program is displayed
and the respective indicator light will
come on.
After a short while, the estimated
program runtime is displayed.
Cleaning the filters
^
Turn the commercial dishwasher off.
^ Turn the handle towards the back to
release the filter combination a.
^ Take the filter combination out b,
remove any coarse particles and
rinse the filter well under running
water. Use a brush if necessary.
,
Ensure that large particles do
not get into the circulation system
and clog it.
Cleaning and care
48