Filter
Top Products
UC360 Configuration
51
Introduction
This chapter describes the following:
• how to launch Settings and configure advanced settings for the UC360 - see “Launching
Settings” on page 51
• how to configure MCD settings for the UC360 - “MCD Programming for the UC360” on
page 76
Refer to the following documents for more information:
• UC360 Installation Guide for instructions on physically connecting the UC360 Collaboration
Point
• UC360 Engineering Guidelines for information on various configuration settings
Launching Settings
1. Press to display the Menu bar
2. Press Settings
The following screen is displayed:
See “Adjusting Brightness” on page 13, “Using Clean Mode” on page 13, and “Unmounting
Media” on page 13 in the section Customizing the UC360.
For Advanced settings, see “Advanced Settings” on page 52 on the next page.